Eladó csodaszép állapotban lévő kifogástalan műszaki állapotú NEXO PS10u felsőkategóriás hangfal.
Nominal Peak SPL @ 1m [b] 124 to 127dB Peak (for 200 to 500 W RMS Amp.)
15 Kg
Fontosabb információk:
Specifications
LF Components 1 x 10" (25 cm) 8 Ohm driver
HF Components 1 x 1" throat driver + Low Distortion, Constant Directivity Asymmetrical Dispersion Horn.
Dimensions Height x Width x Depth 515 x 316 x 277 mm (20.25" x 12.5" x 10.88")
Weight 15 kg (33 lbs)
Connectors 2 x NL4MP SPEAKON 4 pole
Construction Baltic Birch Ply finished with textured, polyurethane black coating
Fittings: Handles 2, integral to cabinet
Front finish Acoustic foam on perforated steel grille (77% transparent)
Flying Points & Fixed Installation
1 steel anchor point for flying track on top (6 positions)
2 steel anchor plates for flying track on bottom (1 position)
Stand fittings Built in Stand Fitting, 35mm (1 3/8")
Frequency Response [a] ;65 Hz - 20 kHz ±3dB (40 Hz - 20 kHz ±3dB with LS500 Subwoofer)
Usable Range @-6dB [a] 58 Hz - 21 kHz (38 Hz - 21 kHz with LS500 Subwoofer)
Sensitivity 1W @ 1m [b 98 dB SPL Nominal - 96 dB SPL Wideband
Nominal Peak SPL @ 1m [b] 124 to 127dB Peak (for 200 to 500 W RMS Amp.)
HF Dispersion [c] 50° to 100° Hor. x 55° Vert. Rotatable Horn, 4 positions
Directivity : Q & DI [c] Q : 16 Nominal DI : 12 dB Nominal ( f 3 kHz )
Crossover Frequencies 2 kHz Passive
Nominal Impedance 8 Ohms
Recommended Amplifiers 200 to 500 Watts into 8 Ohms for 1 x PS10; 400 to 1000 Watts into 4 Ohms for 2 x PS10 per channel
Electronic Controller The PS10 Loudspeaker must be used with a Nexo Controller (PS10 TD analogue, NX241 digital or PS10AMP integrated power amplifier). Use without a properly connected Controller will result in poor sound quality and may damage the components.
Dispersion configuration After removing the quick-release front grille, the HF Horn can be rotated to one of 4 positions for dispersion configuration.
Subbass The PS10 Loudspeaker can be used with or without the optional LS500 Subwoofer. Active two-way operation with the LS500 is included in the PS10TD, NX241 or PS10AMP. One LS500 matches 2 x PS10, additional LS500 may be used for enhanced effect.
Speaker Cables The PS10 is wired 2- & 2+ on Speakon connectors, LS500 on 1- & 1+. Loop through Speakons are present on both products. Single identical cables can thus be used to loop through combinations of up to 2 x PS10 & 1 x LS500 in no particular order.
Weight & Volume 2 x PS.10U = 34 kg (75.1 lbs) 0.169 cu m (5.96 cu ft)
Több darab van belőle, az ár 1 darabra vonatkozik!
Feladás időpontja: | 2024. 03. 09. 18:06 |
Megtekintve: | 351 alkalommal |
Feladó: | euromedia További hirdetései |
Telefonszám: |
0670774
Mutasd!
|
Vármegye: | Veszprém megye |